o All axle and brakes are TÜV inspected
o Parking brakes in series
o Trailer hitch
o Mechanical support
........................................................................
o Beater rotors from thick seam welding, steel tube
o Rotary tine out of strength steel
o Rotary tine screwed
o Each rotor is individually tested for
optimal silent running
o Vertical beater rotors with plates at the
end of tube (for fine grit)
o Oilbath transmission
o Drive from horizontal beater over splited
chain drive
o Transmission over free wheel clutch (broad- spreader with two free wheel clutches)
........................................................................
o Feeder-chains out of special metal G80
combined manganese
o Feeder chain slats out of steel ST70
o Feeder chains galvanized
o Feeder chain drive-wheel out of steel-like cast iron
o Feeder chain input shaft out of special steel
o Each chain can stretchable from the front
o Chain guide-rail galvanized
o Feeder chain guidance with
continuous wooden strips
o Chain-wheels and feeder chain shaft with slide bearing and lubricate system
........................................................................
o Lighting system in series
o Low pressure tyre in series
o Twist frame work
o High load capacity possible
o Laterally closed chain guide
.......................................................................................
o End of the platform with guard-plates
o Dump-body, side boards welded with the steel-platform
o Protective grill as standard
.......................................................................................
o Input shaft out of steel ST60
o Drive shaft with shear clutch
o Drive of feeder-chain by hydraulic
o Beater with direct drive over free-wheel clutch
o Feeder chain drive shaft out of Chrome-Molybdän-Steel
.......................................................................................
with two horizontal rotors and two discs (drive over oil-bath gear-boxes)
o Symmetrical spread pattern (very good characteristics)
o Effective spread width can changed by changing the transmission (540 or 1000 RpM)
o Optimal cutting by blades